Item 1A. Risk Factors
Item 1A. Risk Factors.
In addition to the other information set forth in this report, you should carefully consider the factors discussed in Part I, “Item 1A. Risk Factors” in our Annual Report on Form 10-K filed on March 22, 2024, which could materially affect our business, financial condition or future results. Except as set forth below, we do not believe there have been any material changes to the risk factors that were included in the Company's Annual Report on Form 10-K filed with the SEC on March 22, 2024.
Our failure to meet the continued listing requirements of the Nasdaq could result in a delisting of our Common Stock.
If we fail to satisfy the continued listing requirements of the Nasdaq, such as the corporate governance requirements or the minimum closing bid price requirement, Nasdaq may take steps to delist our common stock. Such a delisting would likely have a negative effect on the price of our Common Stock and would impair your ability to sell or purchase our Common Stock when you wish to do so. In the event of a delisting, we can provide no assurance that any action taken by us to restore compliance with listing requirements would allow our Common Stock to become listed again, stabilize the market price or improve the liquidity of our Common Stock, prevent our Common Stock from dropping below the Nasdaq minimum bid price requirement or prevent future non-compliance with Nasdaq’s listing requirements.
The manufacture and maintenance of our clinical product candidates is complex and we may encounter difficulties in production and maintenance, particularly with respect to clinical material inventory, acquisition of materials, process development or scaling-up of our manufacturing capabilities.
The manufacture and maintenance of our product candidates is complex, highly regulated and subject to multiple risks. The complex processes associated with the manufacture of our product candidates expose us to various manufacturing challenges and risks, which may include delays in manufacturing our product candidates, limits on our ability to increase manufacturing capacity, and the potential for product failure and product variation that may interfere with the timing and scope of our clinical development plans and add additional costs. It is possible that we will make changes to our manufacturing process at various points during product development or commercialization for various reasons, such as controlling costs, achieving scale, decreasing processing time, increasing manufacturing success rate, or other reasons. Such changes can be costly and carry the risk that they will not achieve their intended objectives, or these changes could cause our product candidates to perform differently and affect the results of current or future clinical trials, or the performance of a commercialized product. In some circumstances, changes in the manufacturing process may require us to perform analytical or clinical comparability studies and to collect additional data prior to undertaking more advanced clinical trials, and such studies may introduce additional costs or delays to the program. We may be required to collect additional clinical data from any modified process prior to obtaining marketing approval for the product candidate produced with such modified process. If clinical data are not ultimately comparable to that seen in the earlier trials in terms of safety or efficacy, we may be required to make further changes to our process and/or undertake additional clinical testing, either of which could significantly delay the clinical development or commercialization of the associated product candidate.
Compliance with cGMP requirements and other quality or regulatory issues may arise with our current or any future contract manufacturing organizations (“CMOs”). Furthermore, ongoing stability studies subsequent to manufacture must be periodically conducted to demonstrate that each of our product candidates do not undergo unacceptable deterioration over its shelf life. If issues affecting the quality of our product candidates or those of our CMOs are discovered, the timing and scope of our clinical trials may be delayed or modified and in certain instances such manufacturing facilities may need to be closed for an extended period of time to investigate and remedy the issue. To the extent any adversely affected material is being used in an ongoing clinical trial, the FDA could impose a clinical hold on our trial to investigate and remedy the quality issue. We cannot assure that any manufactured product or product candidate will not suffer a loss in stability or that other issues relating to the manufacture of our product candidates will not occur in the future.
Additionally, our CMOs may experience manufacturing difficulties due to resource constraints, including manufacturing capacity, material constraints, or as a result of labor disputes or unstable political environments. If our CMOs were to encounter any of these difficulties, our ability to provide our product candidate to patients in clinical trials, or to provide product for treatment of patients once approved, would be jeopardized.
Text extracted from the filing as submitted to EDGAR. Formatting, tables and exhibits are simplified for reading; the original document is authoritative for anything you rely on.